airnest mattress care instructions

 airnest mattress

 

Before using the product:

Warning: Not suitable for use in cots where the gap between the mattress and any of the cot sides is greater than 40mm as per AUS/NZ 2172:2013.

To maintain airnest’s breathability do not use with a non-breathable mattress protector.

For the safety of children and animals, please dispose of packaging in a safe and environmentally friendly way.

Do not place in close proximity to a fire, radiator or heater.


Composition:

  • Cover: 100% Polyester
  • Core: 100% Polymer

Washing Instructions:

It isn't necessary for you to wash your mattress before use, but if you would like to, feel free! As the mattress and cover can be cleaned as much as needed, washing before use is completely up to you.

Cover

Unzip the cover and remove it from the mattress core to wash by hand or in a washing machine. If you use a washing machine, make sure you zip the cover closed to avoid snagging the fabric. Use a mild detergent and COLD water. Using hot water may cause the cover to shrink which would make it not fit properly.

Tumble dry on cool settings or hang to air dry.

After washing the cover should go back on the core easily. If the fit has become tight due to shrinkage please contact us immediately for a replacement.

Care

  • Do not soak or bleach
  • Do not iron
  • Do not dry clean ⦻
  • Dry thoroughly before reuse or storage

Core

Place your mattress in the shower or bath, and spot clean the soiled area with mild detergent and COLD water. Shake to release water from the core, and lay it on its side to dry in a well-ventilated area and/or in front of a fan to speed up drying process.

Care

  • Do not use heat to dry
  • Do not dry clean ⦻
  • Dry thoroughly before reuse or storage


    What to avoid:

    Do not use hot water - when washing, use only cold or cool temperature water. Washing with hot water will cause the cover to shrink and not fit properly on your airnest core.

    Do not use heat to dry - Please be sure when speeding up the drying process, to only use cool air solutions. DO NOT USE A BLOW DRYER OR HEATING ELEMENT TO DRY AS HEAT MAY CAUSE THE COVER TO SHRINK AND CAN DAMAGE THE CORE.


    Core made in USA
    Cover made in China
    Assembled in New Zealand
    Tested in accordance and met the voluntary standard: AS/NZS 8811.1:2013 Methods of testing infants products, Method 1: Sleep Surfaces – test for firmness
    Dimensions: 1300x690x120mm (This is one of the most common cot sizes in Australia and NZ, but please confirm the mattress will fit your cot before placing an order)